EGP Details

• EG EGP P De Delilive verrab able les s Details to be mentioned in the presentation are Highlighted slide by slide

Slide no. 1

Commodity / Part under Consideration; Insert an Isometric View of the Part

Slide no. 2 •

Pro rov vide th the Too Tooll Det Deta ails lilike – Type of of tool – Machine Ton Tonn nag age e  – Sh Shri rink nkag age e co cons nsid ider ered ed  – Ov Over eral alll siz size e of of the the to tool ol – Number of of ca cavity  –  –  – –

Mater Mat eria iall of of th the too tooll Matter Ma eria iall of of th the pa part CAD data con consid sidere ered d along along with with date date of CAD CAD receiv received ed Runner details

Slide no. 3

Core side portion & Cavity side portion of the product (show by two different colors)

Slide no. 4

Parting line (dashed one) clearly visible on the part (add more closer views for complex Geometry or at critical areas) Parting line flash should be minimal within 20 microns

Slide no. 5

Show the Gate Point Position & Type of Gate Considered; mention advantage of going with this design or type

Slide no. 6

Show the Sliders, Lifters, Inserts etc. that are required in the tool; Clearly highlight the area getting clear under these.

Slide no. 7

Show the Ejection strategy of the Part (Ejector pin marks impression should be Shown Shown at the ‘B’ surface surface / core core side side of of the part); Justify uniform ejection strategy

Slide no. 8

Mention all the Engraving Details that will Reflect over the part (show the area where Engraving Details will be drafted)

Slide no. 9

Additional Inputs from Supplier’s point of View which are contributing to the DFM (Design for Manufacturing)