Transportation of Machine Transportation of Machine
3
Erection
2. Risk Analysis
3. Risk Control
Existing Risk Control (if any)
Likelihood
Severity
Risk
Major injury/fatal
Nil
4
1
4(Low)
Overturning of Trailer due to uneven surface during transportation Contact with other vehicles Check stability of piles(ties)
Persons
Nil
4
1
4 (Low)
Persons
Nil
4
1
Persons
Nil
3
1
4 (Low) 3(Low)
Crane overturning
Persons
Nil
4
1
4
Recommended Control Measures If working for • height / elevated place height workpermit must be obtained. • Equipment and tools inspection must be carriedout. • To make sure the access road is clear / and level : slow speed. Signal man to be • provided when trailer entering site from main road. Warning signs to be i nstalled on the main road. • Driver responsible to continually check the stability of the load he is transporting Make sure the •
Action by (Due date/status)
during lifting level and base Pile material falling from machine
4
5
Lifting of Pile
Dr iving of Pile
(Low) Persons
Nil
Dragging of Pile too far Improper handling of pile, which could result in damage Swinging of pile
Persons
Nil
Persons
Nil
Persons
Nil
Possibiility of Pile Breaking Equipment not stable. Workers not protected with helmet and hearing protection Damaged Lifting wire on hammer Flush from welding
Persons
Electric shock from welding and other electrical equipment.
Persons
Persons Persons
Persons Persons
4
1
4 (Low)
lifting ggear is adequate andthorough inspection by a competent person iscarried out before mobilization. • Safe protection and support to be given. • Crane certified and inspected by client. • Suitable PPE approved and inspected by client(Helmet, Shoe, Glove etc.). • Place piles near the installation point. • Suitable wire sling to be provided - wire sling certified & inspected by Client • . All person to stand clear • Monitoring by supervisor in charge to make sure no defects on the pile before and during driving. • Ground to be level and able to stand the weight of machine. Supervisor to check • the PPE before work commences and all persons to be trained in the correct use and correct type of PPE especially for hearing protection (possibility that ear plug and ear defenders will need to be worn).. • Supervisor and crane operator to check condition on a regular basis. • Erect welding
6
7
Cutting of piles
Falling piles using hammer
Defective Tools
Persons
Heat Radiation
Persons
Burns
Persons
Oxy-acetylene Cylinders
Persons
Eye injury from debris becoming airborne projectileHand/finger contusion due to improperly striking or missing area to be struckPersonal injury due to defective and/or damaged hammer Personal injury from
Persons
Persons
Persons
Persons
screen to protect other persons in the vicinity from welding flash. • Inspection of all electrical equipment to be carried out before the work starts and during work • Ensure the cutting torch, hoses & gas cylinders are free from defect Wear the required • PPE (Long Sleeve Coverall, apron, safety Goggle etc) • Wear long sleeved coverall & apron. • Use leather hand gloves. • Keep First Aid Kit at site • Keep Oxy-acetylene Cylinders safely at least 5 meters away from the work location. • Never use domestic LPG cylinder for cooking. • Close the isolation valve at cylinders when not in use Wear safety glasses • or face shield• Watch the area you are hitting. Keep opposite hand at a safe distance from area to be struck. Use vise or other holding device as necessary. Do not raise the hammer excessively and strike using massive blows. Strike a hammer blow squarely with the striking
misuse of hammerPersonal injury from using incorrect hammer for intended task
Persons
face parallel to the surface being struck. Avoid glancing blows and over and under strikes.• Visually inspect hammer before each use. Do not use a hammer with a loose or damaged handle or head. • Hold the hammer with your wrist straight and hand tightly wrapped around the handle. Look behind and above before swinging a hammer. Do not strike with side of the hammer. • Select and use a hammer according to its intended use