it is good book for entrance exam like iit. it is published by TMH 2012
physics investigatory project
Test Series
physics, basic physics, SI units and derived unitsFull description
physics solved problems
it is good book for entrance exam like iit. it is published by TMH 2012Full description
physics
physics reviewer
it is good book for entrance exam like iit. it is published by TMH 2012
it is good book for entrance exam like iit. it is published by TMH 2012
Full description
Geas ReviewerFull description
Full description
nm
Full description
dynamicsFull description
╞╡§¥ Physics
Physics Paper 3 Answer Guide
SPM 2013
STRUCTURE OF ANSWER The most important thing when answering this question is to correctly identify the manipulated variable variable and the responding variable. variable . The following answer structure is a suggested guide. Fill in the relevant manipulated and responding variables based variables based on the question. (a) Inference Manipulated variable affects variable affects responding variable. variable .
Marks allocated: 1
Note: Inference is a cause and effect statement. The inference should be written based on what is observed in the diagram. (b) Hypothesis The greater the manipulated variable, variable, the greater/lower the responding variable. variable. Marks allocated: 1
Note: Hypothesis can only investigate physical investigate physical quantities quantities.. Make sure you write out the physical quantity that is being studied. For example: The thinner the wire, the higher the resistance IS WRONG BECAUSE THE PHYSICAL QUANTITY IS NOT MENTIONED IN THE MANIPULATED VARIABLE.
Also, avoid using terms terms like “directly proportional ” or ” inversely inversely proportional ”. These are conclusions to be made based on the results and graph.
(c) Marks allocated: 1 (i) Aim To study the relationship between the manipulated variable and variable and the responding variable. variable. (ii) Variables Manipulated variable: Responding variable: Constant variable: one is sufficient
Marks allocated: 1 Marks allocated: 1
Note: Write only physical only physical quantities quantities.. Do not write objects. (iii)Apparatus and materials Marks allocated: 1
Note: You can write the entire list in one line. Ensure you include the measuring instruments to measure the manipulated variable, the responding variable, and the constant variable (where applicable) (iv) Arrangement of apparatus
Marks allocated: 1
Note: This is the drawing of the setup of the experiment. Draw in pencil COMPLETE COMPLETE WITH LABELS .
Hoo Sze Yen
www.physicsrox.com
Page 1 of 4
╞╡§¥ Physics
SPM 2013
Physics Paper 3 Answer Guide
(v) Procedure 1. Method to control the manipulated variable – state the initial value of the manipulated variable 2. Method to measure the responding variable 3. Experiment is repeated with 4 more values of the manipulated variable – specify the 4 values!
Note: The values of the manipulated variable MUST BE LOGICAL and can be conducted in a school laboratory. The repetition of the experiment in step 3 MUST HAVE VALUES. DO NOT write “the experiment is repeated with 4 other values. You will not get marks if you do! Marks allocated: 3 (vi) Tabulation of Data Manipulated variable (unit) Fill up with the values specified in your procedure
Responding variable (unit)
Marks allocated: 1
(vii)
Data Analysis A graph of responding variable against manipulated variable is plotted Responding variable (unit)
Manipulated variable (unit)
Note: Draw only the axes and label them with the corresponding variables and units. You do not need to plot a graph, draw a best fit line, or write a title.
Hoo Sze Yen
www.physicsrox.com
Page 2 of 4
╞╡§¥ Physics
Physics Paper 3 Answer Guide
SPM 2013
SAMPLE QUESTION A Section B question looks typically like this:
Figure 1(a)
Figure 1(b)
Figure 1(a) shows a small car stopping suddenly after moving at constant speed of 80 km hr -1 when the driver sees the landslide in front of him on the road. Figure 1(b) shows a big truck that was moving at the same speed, but is not able to stop at a safe distance when the driver sees the landslide. Based on the above observations: (a) State one suitable inference that can be made. [1 mark ] (b) State one appropriate hypothesis for an investigation. [1 mark ] (c) Describe an experimental framework to test your hypothesis. Choose appropriate apparatuses such as a jigsaw blade, plasticine, and other suitable apparatus. In your description, state clearly the following: (i) Aim of the experiment (ii) Variables in the experiment (iii) List of apparatus and materials (iv) Arrangement of the apparatus (v) The procedure of the experiment which includes the method of controlling the manipulated variable and the method of measuring the responding variable (vi) Way you would tabulate the data (vii) Way you would analyse the data [10 marks]
Hoo Sze Yen
www.physicsrox.com
Page 3 of 4
╞╡§¥ Physics
Physics Paper 3 Answer Guide
SPM 2013
SAMPLE ANSWER (a) Inference: Mass affects its inertia (b) Hypothesis: The greater the mass of an object, the greater its inertia (c) (i) Aim of the experiment: To study the relationship between the mass of an object and its inertia (ii) Variables: Manipulated: Mass of plasticine Responding: Inertia OR period of oscillation Constant: Stiffness of jigsaw blade OR distance of plasticine ball to clamp (iii) Apparatus/Materials: Jigsaw blade, G-clamp, stopwatch, and plasticine spheres of mass 20 g, 40 g, 60 g, 80 g, and 100 g (iv) Arrangement of apparatus:
Method to control the manipulated variable
(v) Procedure: 1. The experiment is setup as shown above. 2. A 20.0 g plasticine sphere is fixed at the free end of the blade. 3. The free end of the blade is displaced horizontally and released so that it oscillates. The time for 10 complete oscillations is measured using a stopwatch. The period of oscillation is calculated using
T
t
10
Method to measure the res ondin variable
.
4. The experiment is repeated using plasticine spheres of masses 40.0 g, 60.0 g, 80.0 g, and 100.0 g. Experiment is repeated
(vi) Tabulation of data: Mass of plasticine sphere (g) 20.0 40.0 60.0 80.0 100.0
Time for 10 oscillations (s)
Period of oscillation (s)
(vii) Data analysis: A graph of period against mass is plotted. Period of oscillation s