Agustinus Agus Purwanto, SE MM www.sunparadisehotelsmanagement.com Email: [email protected] Mobile: +62 812 9444 1224
Kobelco SK200-8 Super _Fuel systemDeskripsi lengkap
Deskripsi lengkap
Kobelco SK200-8 Super _Fuel systemFull description
Full description
Descripción completa
Deskripsi lengkap
Agustinus Agus Purwanto, SE MM www.sunparadisehotelsmanagement.com Email: [email protected] Mobile: +62 812 9444 1224
Full description
Deskripsi lengkap
Full description
Descripción completa
manual calderos cleaver brooks package . resumen de diferentes calderos pirotubularesDescripción completa
Descripción completa
Descrição completa
Manual for applying on Universiy of TIlburg, research master in philosophyFull description
Installation Information CAUTION!! The Printed Circuit Boards of SK-200 are sensitive to static electricity. During installation and maintenance, take precautions against static damage. Printed Circuit Board Insertion
Raise the Extractor of the Printed Circuit Board, with components facing right. Hook the extractor onto the m etal edge of the case, press down the extractor, and push the Printed Circuit Board into the slot until it is fully inserted. Power Supply Installation
The Power Supply for the unit can be configured for : 110-VAC: 100 to 120 V AC (50/60Hz) or 220-VAC: 210 to 230 V AC (50/60Hz). Select the input voltage by the 110/220 jumper on the SK-PWR/2 It is important to verify that the setting is correct prior to initial system power up. Verify that the input voltage and input voltage jumper are correct before you power up the system. Installation steps:
Check the Jumper for the input voltage on the SK-PWR/2 to assure that it is correct for your power source. Insert the SK-PWR/2 into left-most card slot of the Main Cabinet. Secure the power supply unit by the screws.
