Apache RTR 200 Service Manual

PERIODIC MAINTENANCE

l

TVS APACHE RTR 200

SERVICE MANUAL

Remove the hexagonal bolts (M6x16 - 4 nos.) from both LH & RH mounting wheel hugger rear mounting. (Fig. 2.95A & B) 10 mm spanner Tightening torque

8 ± 2 Nm

Fig. 2.95A l

Fig. 2.95B

Loosen the hexagonal flanged U-nut (M14x1.5) of axle rear. (Fig. 2.96A) 22 mm spanner

 A C

Tightening torque l

78 ± 18 Nm

Similarly, loosen the chain adjuster bolts (A and B) to some extended in order to remove the chain. (Fig. 2.96B)

B

12 mm spanner Fig. 2.96A l

Remove the hexagonal bolts (M6x12 - 2 nos.) along with the washers from the chain guard. (Fig. 2.97) 10 mm spanner Tightening torque

8 ± 2 Nm

Fig. 2.97 l

l

l

l

Push the rear wheel from the back towards front so that the drive chain loosens and hangs as shown. (Fig. 2.98) Now, lift the chain guard upward. Gently take out the drive chain by dislocating it from the rear sprocket and swing arm assembly. Clean the drive chain by dipping it in kerosene. Brush off any dirt / dust sticking to it. Drain / dry the kerosene by hanging the chain for 5 minutes.

Fig. 2.98

Fig. 2.96B