LTE Radio Parameters RL60 - Power Control-NokiaDeskripsi lengkap
ΧΑΡΟΚΟΠΕΙΟ ΠΑΝΕΠΙΣΤΗΜΙΟ Τμήμα Γεωγραφίας Πρόγραμμα Μεταπτυχιακών Σπουδών «Εφαρμοσμένη Γεωγραφία και Διαχείριση του Χώρου» Κατεύθυνση: Ανάπτυξη και Διαχείριση του Ευρωπαϊκού χώρου ΝΕΕΣ ΚΟΙΝΩΝΙΚ...
LinkFull description
Descrição: link proxy
LTE Radio Parameters RL60 Idle Mode Mobility-NokiaDeskripsi lengkap
LTE Parameters
thermodynamicsFull description
13 3Descripción completa
Full description
Ericsson Mobility ParametersFull description
Radi Ra dio o Link Li nk Parameters Parameters
Ceragon Cera gon Trainin g Services May 2014 version 1
Ag end a • MRMC • TX & RX Frequencies • Link ID • RSL • MSE • Current ACM Profile
2
Proprietary and Confidential
High and Low frequency s tation Tx(f1)=11500 MHz
Rx(f1)=11500 MHz
Full duplex
Local site High station
Remote site Low station Tx(f1’)=11000 MHz
Rx(f1’)=11000 MHz
High station means: Tx(f1) >Rx(f1’) Low station means: Tx(f1’) < Rx(f1)
Proprietary and Confidential
3
Radio Link Parameters TSL
IDU
ODU
))
)
RSL
ODU
IDU
To Establish a radio link, we need configure fo llowing parameters: 1. MRMC – Modem scripts (ACM or fixed capacity, channel & modulation) 2. TX / RX frequencies – set on every radio 3. L in k ID – must be the same on both ends 4. Max. TSL – Max. allowed Transmission Signal [dBm] 5. Unmute Transceiver – Transceiver is by default muted (is not transmitting) ------------------------------------------------------------------------------------------------------To verify a radio link, we need control followi ng parameters: 1. RSL – Received Signal Level [dBm] – nominal input level is required 2. MSE- Mean Square Error [dB] 3. Current ACM profile
4
Proprietary and Confidential
MRMC – Multi Rate Mult i Coding Prof iles Modulation
LINK ID – Antenna Alignment Process To avoid pointing the antenna to a wrong direction (when both links share the same frequency), LINK ID can be used to alert when such action is take.
# 101 # 101
# 102
“Link ID Mismatch”
# 101 “Link ID Mismatch”
8
Proprietary and Confidential
LINK ID – Antenna Alignment Process Both IDUs of the same link must use the same Link ID Otherwise, “Link ID Mismatch” alarm will appear in Current Alarms Window
