JSA-Working at Height

SGD SAIPEM CAMP ACCOMODATION AND BUILDING FACILITIES JOB SAFETY ANALYSIS PROJECT OPERATIONAL CAMP

JSA NO. 003

Date 10/01/2013

Activity: Electrical works

Steps

Scaffoldings.

Page 1 of 2

Hazards

 Fall of materials.  Fall of personnel.  Collapse of scaffolding.  Improper access and egress.

Control Measures to be Enforced

 All scaffolding materials should be inspected and approved.  Inspection of all scaffolding structure should be carried out after each deconstruction of all scaffoldings by a qualified scaffolding inspector.  Obtain scaffold construction permit prior to start the work.  Ensure the area is barricaded to prevent any unauthorized personnel entry.  All scaffoldings shall be erected by qualified and competent personnel under the supervision of a scaffolding supervisor.  Inspection of scaffolding shall be done by a qualified scaffolding inspector.  No one else is permitted to alter any scaffolding without the approval of scaffolding inspector.  Scaffoldings must be fitted with toe boards to prevent the fall of materials and tools. All tools and materials shall be properly secured in the scaff platform.  All personnel entering in the scaffolding must be physically fit for the job and shall not be afraid of heights.  Personnel must wear full safety harnesses while working at heights. 100% tie‐off shall be maintained while working at heights.  Weekly Inspections should be carried out.  Scaff tag should be available on all scaffoldings.

Remarks / Actions

SGD SAIPEM CAMP ACCOMODATION AND BUILDING FACILITIES JSA NO. 003

JOB SAFETY ANALYSIS PROJECT OPERATIONAL CAMP

Page 2 of 2 Date 10/01/2013

Activity: Electrical works

Working at Heights.

 Fall from height.  Unsafe working platforms and working conditions.  Unsafe access / egress.  Hit by the structure.

Supervisor / Operators.  Any person working above 2m height shall be considered as working at height.  Ensure all personnel assigned to work at height are not afraid of height and medically fit for height works.  Work shall not be allowed to be carried out standing over wooden boxes; empty barrels and other make shift arrangements.  In case of any practical difficulties to provide proper working platform, safety harness with fall arrestors (self inertia reels) shall be installed and used.  Temporary edge protection with top hand rails at a height of 1.1mand mid rail at a height of 0.55 m and with toe board shall be installed in all around the openings in floor slabs.  For small openings floor covers shall be provided with adequate strength.  Stop work at height in high wind velocity. Home made ladders not to be used; Ladders with broken rug not to be used; Placement of ladder to be in proper securing position.

Name Approved By:

Sheikh Ismail

Signature

Date