This document is a quick handbook for ATG Site & Search Setup. This document is based on my hands-on ATG experience. Document details out ATG Site and Search Setup step by step. The target audie...
conector OBD2Descrição completa
Descripción: Install Free Radius on linux Centos 6 an ubuntu 11
dda
Install and Configure Computer System
Computer Hardware Servicing
TAFJ Set up on T24 banking system R14 and aboveDescripción completa
Fault status LED 4 network ports RM (Remote Management) port Shelf ACP port (e0P)
Shutting down a controller module Shut down the target controller module (called a “node” in an active/active configuration) by completing the applicable procedure: If you have an active/active configuration
CAUTION
LIFTING HAZARD
For hot-swappable FRUs: Always consult http://now.netap current field-replaceable unit (FR replacement procedures.
30 kg (67 lbs)
1. Check the status of the target node by entering the following command at the system console of either node: cf status
2. Take one of the following actions, depending on the result of the cf status command: IF clustering is enabled and neither node is in takeover mode, go to step 3.
Removing the cable management arms
For hot-swappable power sup System shuts down two minutes remove a power supply.
IF clustering is enabled and the target node took over the partner node, correct the problem, run the cf giveback command from the target node console, and go to step 1.
partner> cf takeover
4. Go to “Opening the system” when the takeover is complete. If you have a single-controller configuration 1. Enter the following command from the system console: halt
Adding external storage or usi You must order and use SFP mo your system, if you are connectin FC storage devices or using FC system.
Important:
IF clustering is enabled and the partner node took over the target node, go to “Opening the System.”
3. Take over the target node by entering the following command from the partner node’s console:
Important:
Disk drive
You're Power supply Reading a Preview
Unlock full access with a free trial.
Releasing a disk drive
Download With Free Trial
2. Turn off the power supplies and unplug both power cords from the power source.
Attention: Disk drives are fragile. Do n except when replacing failed disk drive to a new chassis.
3. Check the nonvolatile memory (NVMEM) LED. IF the LED is not flashing, go to “Opening the System.” IF the LED is flashing, there is content in the NVMEM that has not been saved to disk. Reconnect the power supplies to the power source, reboot the controller module, and repeat Steps 1 through 3. If repeated attempts to cleanly shut down the controller module fail, be aware that you might lose any data that was not saved to disk. Go to “Opening the System.”
Opening the system
Cam handle
Closing the system
1. Align the controller module cover with the the controller Sign up to votesides onofthis title module, then slide
Controller module
Thumbscrew Controller module cover
Useful
and forward to seat it.
Not the useful end of the controller module wit 2. Align the chassis.
3. Gently push the controller module halfwa chassis and recable the controller modul
