FABRICATION OF TURBOCHARGER IN TWOWHEELER A PROJECT SUBMITTED IN PARTIAL FULFILLMENT OF THE REQUIREMENTS FOR THE AWARD OF THE DEGREE OF BACHELOR OF EN...
1. INTRODUCTION There are two kinds of manifolds that are part of an engine’s breathing system: the intake manifold and the exhaust manifold. Manifolds are carefully designed to provide a uniform a...
first hand data
The percentage of pollutants in the air from vehicular emission has increased as market constitutes of more fossil fuel powered vehicles than new green technology. Now days demand of the fossil fuel is reduced in the market we are encourage the new t
Full description
this Document contain almost all knowledge about the Turbocharger technology.
Bajaj motorsFull description
This project explains about a two wheeler carburator in brief. It also produces the procedure involved in designing and analysis of the above mentioned topic.
Full description
Makalah ini ditulis selain bertujuan untuk memenuhi tugas mata kuliah mesin-mesin fluida juga agar kita dapat mempelajari tentang mesin fluida terutama mengenai turbocharger.Deskripsi lengkap
Makalah ini ditulis selain bertujuan untuk memenuhi tugas mata kuliah mesin-mesin fluida juga agar kita dapat mempelajari tentang mesin fluida terutama mengenai turbocharger.Full description
Pembahasan perawatan turbocharger
Operation manual
fffFull description
Motion in Two DimensionsFull description
To determine the Rf values of dyes used in candies. (using chromotography)
INFORMATION TECH. ROLES IN INSURANCE INDUSTRY. FINAL YEAR PROJECT.
FABRICATION OF TURBOCHARGER IN TWOWHEELER
A PROJECT SUBMITTED IN PARTIAL FULFILLMENT OF THE REQUIREMENTS FOR THE AWARD OF THE DEGREE OF BACHELOR OF ENGINEERING IN MECHANICAL ENGINEERING TO HEMCHANDRACHARYA NORTH GUJARAT UNIVERCITY BY
KETAN B. PATEL VIJAY R. PATEL NIRAJ P. PATEL RAHUL PATEL GUIDED BY PROF. ANUP B. PATEL PROF. SHAILESH N. CHUDHARY
DEPARTMENT OF MECHANICAL ENGINEERING L.C. INSTITUTE OF TECHNOLOGY BHANDU - 384120. GUJARAT, INDIA JUNE ‘2011
L.C. INSTITUTE OF TECHNOLOGY BHANDU - 384120.
This is to certify that the work presented in the project entitled FABRICATION OF TURBOCHARGER IN TWO WHEELER has been carried out by “
”
KETAN B. PATEL (1354) VIJAY R. PATEL (1372) NIRAJ P. PATEL (1363) RAHUL PATEL (1367)
in a manner sufficiently satisfactory to warrant its acceptance as a partial fulfillment of the requirement for the award of the Degree of the Bachelor of Engineering in Mechanical Engineering . This is a bonafide work done by the student and has not been submitted to any other University/ Institute for the award of any other Degree/ Diploma. “
Guide
Prof .ANUP B. PATEL Prof. SHAILESH N.CHUDHARY
Head of Department
Prof. DIPAK M. Patel
DEPARTMENT OF MECHANICAL ENGINEERING L.C. INSTITUTE OF TECHNOLOGY BHANDU - 384120. GUJARAT, INDIA
JUNE ‘201
Project approval Sheet
The Project Entitled FABRICATION OF TURBOCHARGER IN TWO WHEELER
Submitted by Ketan B. Patel, Vijay R. Patel, Niraj P. Patel and Rahul Patel Of L. C. Institute of Technology, Bhandu is approved for the award of the degree of Bachelor of Engineering (Mechanical) of Hemchadracharya North Gujarat University.
