Cisco Packet Tracer 7.3.1.8 Packet Tracer - Configuring RIPv2

 Script Code For Cisco Packet Tracer 7.3.1.8 Packet Tracer - Configuring RIPv2 Cisco Packet Tracer 7.3.1.8 Packet Tracer - Configuring RIPv2 R1 R1 R1 R1 R1 R1 R1 R1 R1 R1 R1 R1 R1

> enable # configure terminal (config)# ip route 0.0.0.0 0.0.0.0 s0/0/1 (config)# router rip (config)# version 2 (config)# no auto-sumarry (config-router)# do show ip route connected (config-router)# network 192.168.2.0 (config-router)# network 192.168.1.0 (config-router)# passive-interface g0/0 (config-router)# default-information originate (config-router)# end #

R2 R2 R2 R2 R2 R2 R2 R2 R2 R2 R2 R2

> enable # configure terminal (config)# router rip (config)# version 2 (config)# no auto-sumarry (config-router)#do show ip route connected (config-router)# network 192.168.2.0 (config-router)# network 192.168.3.0 (config-router)# network 192.168.4.0 (config-router)# passive-interface g0/0 (config-router)# end #

R3 R3 R3 R3 R3 R3 R3 R3 R3 R3 R3

> enable # configure terminal (config)# router rip (config)# version 2 (config)# no auto-sumarry (config-router)# do show ip route connected (config-router)# network 192.168.4.0 (config-router)# network 192.168.5.0 (config-router)# passive-interface g0/0 (config-router)# end #