This very good product produced by PETRONAS for the application of marine engine
This is Disrol 300 marine engine oil specially develop by PETRONAS for the application in the marine engine
good research work
Full description
Description complète
Full description
Pági Página na 1 de de 4
Cerrar SIS Pantalla anterior
Producto: GENERATOR SET Modelo: 3516B GENERATOR SET GD3 Configuración: 3516B Generator Set GD300001-UP
Pruebas y Ajustes 3500B and 3500C Generator Set Engines Núm Número ero de de med mediio -RE -REN NR505 R5058 8-06 -06
Fech Fecha a de de pub publlicac icaciión -01 -01/02/ /02/20 2013 13
Fech Fecha a de de act actua uali liza zac ción -07/ 07/02/2 02/201 013 3
i05187146
Engine Oil Pressure - Test SMCS - 1304-081
Specifications Table 1 Parameter
Value
Engine Oil Pressure at rated rpm
280 to 600 kPa (40 to 87 psi)
Minimum Engine Oil Pressure at low idle
140 kPa (20 psi)
Required Tools Table 2 Required Tools Part Number
Qty
Engine Pressure Gp 1U-5470 En
1
12/05/2016
Página 2 de 4
Illustration 1
g00296486
1U-5470 Engine Pressure Group
The 1U-5470 Engine Pressure Group measures the engine oil pressure in the system. This engine tool group can read the engine oil pressure inside the oil manifold. Note: Refer to Special Instruction, SEHS8907, "Using the 1U-5470 Engine Pressure Group " for more information on using the 1U-5470 Engine Pressure Group . Note: The engine oil pressure can also be measured by using an electronic service tool. Refer to Troubleshooting for information on the use of the Caterpillar Electronic Technician (ET).
Test Preparation
Work carefully around an engine that is running. Engine parts that are hot, or parts that are moving, can cause personal injury.
NOTICE Keep all parts clean from contaminants. Contaminants may cause rapid wear and shortened component life.
NOTICE
12/05/2016
Página 3 de 4 Care must be taken to ensure that fluids are contained during performance of inspection, maintenance, testing, adjusting, and repair of the product. Be prepared to collect the fluid with suitable containers before opening any compartment or disassembling any component containing fluids. Refer to Special Publication, NENG2500, "Dealer Service Tool Catalog" for tools and supplies suitable to collect and contain fluids on Cat products. Dispose of all fluids according to local regulations and mandates.
1. Turn of the engine.
Illustration 2
g00751796
Location of the oil gallery plug Typical example (1) Plug
2. Remove plug (1) . 3. Install the 1U-5470 Engine Pressure Gp into the open oil gallery port. 4. Install the 1U-5470 Engine Pressure Group into oil gallery plug (1) .
Test Procedure 1. Check the engine oil pressure to the camshaft and main bearings on each side of the cylinder block at oil gallery plug (1) . 2. Start the engine. Run the engine with SAE 10W30 or SAE 15W40 oil. Refer to Operation and Maintenance Manual, "Engine Oil" for the recommendations of engine oil. Note: Allow the engine to reach operating temperature before you perform the oil pressure test. Note: The engine oil temperature should not exceed 115 °C (239 °F).
3. Record the value of the engine oil pressure when the engine has reached operating temperature. 12/05/2016
Página 4 de 4 4. A record of engine oil pressure can be used as an indication of possible engine problems or of damage. A possible problem could exist if the engine oil pressure suddenly increases or decreases 70 kPa (10 psi) and the engine is not at normal engine oil pressure. Inspect the engine and correct the problem. 5. Compare the recorded engine oil pressure with the engine oil pressure indicators on the instrument panel and the engine oil pressure that is displayed on the Cat ET. 6. An engine oil pressure indicator or sensor that has a defect can give a false indication of engine oil pressure. If, there is a notable difference between the engine oil pressure readings make necessary repairs. 7. If the engine oil pressure is low, refer to Testing and Adjusting, "Engine Oil Pressure is Low" for the possible causes of low engine oil pressure. 8. If the engine oil pressure is high, refer to Testing and Adjusting, "Engine Oil Pressure is High" for the possible causes of high engine oil pressure. Copyright 1993 - 2016 Caterpillar Inc.
Thu May 12 03:10:43 UTC-0400 2016
Todos los derechos reservados. Red privada para licenciados del SIS.
